Breville the Fast Slow Pro BPR700 Manuel D'instructions page 13

STOP/CANCEL BUTTON AND
STANDBY MODE
Pressing the STOP/CANCEL button during
any cooking cycle will pause the cycle for up to
5 minutes. If the cycle is not restarted during
this time, the cooker will go into standby mode.
Pressing the STOP/CANCEL button during
setup or while the cooker is paused will return
to the previous screen.
Pressing the STOP/CANCEL button from the
main settings menu will switch the cooker to
standby mode.
Press and hold the STOP/CANCEL button for
2 seconds at any time to enter standby mode.
If there is pressure inside the cooker when it
switches to standby mode, it will instead switch
to pressure release mode with Natural release
selected. Press the RELEASE button to switch
to a different release method or press and hold
the RELEASE button for an extended release.
ALTITUDE ADJUST
At higher altitudes, the temperature at which
water boils decreases as a result of the drop
in air pressure. This lower air pressure creates
very different conditions for cooking with a
pressure cooker.
In order to maintain consistent cooking results
at various altitudes, the Fast Slow Pro™ has an
Altitude Adjust feature that adjusts the settings
based on the altitude of your current location.
1. To enter Altitude Adjust mode, press and
hold STOP/CANCEL to activate standby
mode. The button backlight will go out and
the LCD screen will no longer illuminate.
2. Once in standby, press and hold both the
KEEP WARM and RELEASE buttons for
2 seconds. 'ALt' will appear on the screen.
3. Turn the TIME dial to enter the altitude
of your current location. Altitude can be
adjusted from 1,000 ft to 6,000 ft in
1,000 ft increments. The pressure cooker
should not be used above 6,500 ft.
4. Press the START/SELECT dial to confirm.
5. The cooker's settings have now been
adjusted for your current altitude. To reset
to the factory setting (sea level), unplug
cooker from the power outlet and press
and hold START/SELECT while plugging
it back in. The letter 'd' and a number will
briefly appear on the screen, confirming the
reset to factory settings.
13