habitat et jardin Courso Mode D'emploi page 11

11. Run belt Adjustment
1) Running belt deviate to left
Start the machine by speed at 2-3Km/h without loading, use die nut to make the screw
go 1/4 circle(see fig1). Then make the machine running without loading 1-2 minutes.
Please adjust like this to make the belt till to mid place.
2) Running belt deviate to right
Start the machine by speed at 2-3Km/h without loading, use die nut to make the screw
go 1/4 circle(see fig2). Then make the machine running without loading 1-2 minutes.
Please adjust like this to make the belt till to mid place.
3) Running belt logjam
If the running belt is in dead condition, use die nut to make the screw 1/2 circle both left
and right till this logjam solved.
12. Daily Maintain
1. Please switch off and cut off power before checking the machine or clearance.
2. Clear belt and dial plate after used, one time every week at least.
3. Check and tight screws and spines at fixed period.
4. Do not hang up clothes etc to the machine,
2021-2022