Publicité
Les langues disponibles
Les langues disponibles
WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1 | Tel. +49 (0)7062-91556-0 | Fax +49 (0)7062-91556-10 | E-Mail info@wolff-tools.com |
Internet
www.wolff-tools.de
7
Installation
Install the wheel assembly to
the cutter base with provided
bolts and nuts as shown.
Then insert the handle into
the handle base as show and
tighten provided screw.
Warning: Do not put your
fingers against the sharp
edge of the blade at any time.
Straight Cut
Insert material between the
cutting blade and the base,
flush it with the guide bar as
shown and hold the material
then press handle down to
complete a cut.
Warning: Maintain control of
the handle. Do not allow
handle to slam back after
making a cut.
Publicité
