Roadstar CLR-2750 Manuel D'instructions page 5

WAKE TO THE RADIO
1. Set the alarm time as shown above.
2. Follow the procedure in LISTENING TO THE RADIO to tune the
radio to a station.
3. Set the VOLUME Control (8) to a level you feel will wake you.
4. Set the FUNCTION Selector (9) to the AUTO position. ALARM 1
indicator will light up on the top right side of the display.
5. To switch off the alarm either press the AL. OFF Button (4) or set
the FUNCTION Selector (9) to the STANDBY position.
LISTENING TO THE RADIO
1. Set the FUNCTION Selector (9) to the ON position.
2. Turn the TUNING Knob (12) until the desired station is heard.
4. Adjust the VOLUME Control (8) to a comfortable listening level.
5. To turn off the radio, set the Function Selector (9) to the STANDBY
position.
Note: For FM reception there is a built-in FM antenna wire at the rear
of the unit. Move the wire around to obtain the best reception.
English 5 6
SNOOZE FUNCTION
When the alarm sounds, pressing the SNOOZE Button (3) will temporary
stop about 8 minutes then the alarm sounds again.
SLEEP FUNCTION
1. This function enables you to go to sleep listening to the Radio.
2. Set the FUNCTION Selector (9) to STANDBY or AUTO.
3. Press the SLEEP Button (2). The clock display will show 59 minutes.
4. To select a shorter time press the MINUTE Button (6) while holding
5. To turn off the Radio at any time during the Sleep period, press
DIMMER FUNCTION
Select display illumination level with the DIMMER Selector (13).
CARE AND MAINTENANCE
To prevent fire or shock hazard, do not allow this clock radio to be
exposed to rain or moisture.
This clock radio should not be exposed to direct sunlight, very high or
low temperature, moisture, vibration, or placed in a dusty environment.
English
The Radio turns on and will turn off automatically after 59 minutes.
the SLEEP Button (2) until the desired sleep time is displayed.
the ALARM//SLP OFF Button (3).