power2max NGeco Guide De Démarrage Rapide page 7

Installation and operation:
- Remove the isolation strip by pulling it out of the battery compartment.
The LED indicator is now flashing green. Check if the battery cap
is in the correct position (picture).
- connect the power meter to your bike computer or your Bluetooth-enabled
smartphone (observe manufacturer's instructions).
- Install chainrings onto the power meter. (Installation instructions
at www.power2max.com.)
- Install the power meter at the crank. (Installation instructions at
www.power2max.com. Observe manufacturer's instructions for torque
values!)
- Install the crankset on the bicycle. (Installation instructions at
www.power2max.com. Observe manufacturer's instructions for torque
values!)
- After installing, check the function of the front derailleur and adjust
as necessary.
Finished!
Now: go ride and have fun with your power2max NG !
eco
7