Publicité
Les langues disponibles
Les langues disponibles
Channel selector switch
A switch for choosing the desired channel is located on the upper side of the device.
1:
Operating frequency 3,8 MHz
2:
Operating frequency 3,3 MHz
3:
Operating frequency 2,8 MHz
4:
Operating frequency 2,3 MHz
How to attach the carrying cord / belt clip
The receiver includes a carrying cord and belt clip, which can be attached to the rear
side of the device. To attach the clip to the receiver, place the clip on the hook 5 on
the back of the device. Now turn the clip 180° until it snaps into place.
Connecting accessories
You can connect any listening accessory with a regular 3.5 mm stereo jack with the
audio output 6 of the IR-RX2, like:
- Under-the-chin headphones
- Regular earphones
- In-Ear phones
- Inductive neckloops
Using the IR-RX2
Switch the device on by means of the volume control. The red LED lights up when the
device is switched on. Make sure that the connected audio source is switched on and
adjust the volume of the IR-RX2 according to your preference.
4
- Audio-Cable binaural
- Audio-Cable monaural
- Induction Link binaural
- Induction Link monaural
EN
English 5
Publicité
