Installationand Use; Safety Instructions; Use - Casselin CVRE120L Mode D'emploi

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.

5.2 Use

WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
Manual :
- The device must be completely removed from its packaging. All guards must be completely removed.
- Place the appliance upright on a solid, flat surface Never put the refrigerated display case on a flammable
surface. Position this machine in such a way as to ensure optimum air circulation. We advise you to keep a
minimum distance of 10 cm from the wall and other objects.
- Do not install this device near open fires or other heating devices.
- Do not install the device in a wet or damp place.
- The electrical cable must be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a power strip will trip the device.
- In order to avoid damaging the compressor, the appliance must not be tilted
more than 45° during transport or installation.
- Leave the appliance to rest for 2 hours before using it for the first time.
- Before use, the device must be cleaned
- Connect the device and press the ON button, choose the desired temperature. Do not put the drinks until
the desired temperature has been obtained.
- LCD indicator: the indicator lamp is on during the cooling phase and remains off as long as the temperature
of the refrigeration chamber is stable and flashes when the compressor remains off for too long.
- LCD defrost indicator: the appliance is equipped with an automatic defrost which is activated 4 times over
24 hours. The pilot light comes on during the defrost phase and goes off when the defrost is finished. It
flashes when the appliance has not been defrosted for a long time.
- Manual defrosting is also possible if the efficiency of the refrigeration decreases, as for example during an
untimely opening.
- Any hot dish must be cooled before inserting it into the appliance.
- The height of the shelves must be adapted to the height of the dishes. Dishes should be properly spaced
to maximize the effect of refrigeration.
EN