Bushnell 119986C Mode D'emploi page 3

About the Solar Panel
The Bushnell Solar Panel accessory (#119986) is designed
to function as a supplemental source of power for all
current models of Trophy Cam HD Aggressor, Trophy Cam
HD Aggressor Wireless, Impulse, Core, CelluCore, and
Prime series cameras. With the Solar Panel mounted near
your camera and connected to its external power input
jack, you will find that your camera's batteries last much
longer before they need to be replaced. The solar panel has
an internal lithium ion power core, which is continuously
charged by the solar cells when they are exposed to the
sun. Once connected, the camera will draw its power from
the solar panel's charged lithium battery for as long as
possible, switching to its internal batteries only when the
Solar Panel's battery's charge level is too low. As a result,
the camera's batteries will have significantly longer life.
Charging the Solar Panel Via USB
The Solar Panel also includes a USB port allowing the
internal power core to be "pre-charged" before field use,
from a computer's USB connection or similar available
source of USB power. Doing this is NOT required prior to
use but will allow it to begin providing supplemental power
to your camera immediately, instead of waiting for the
solar cells to build up adequate charge.
4
To use this feature, connect a compatible USB Mini cable
(not included) from the Solar Panel to your computer or
an adequate power source. The charging indicator LED on
the back of the Solar Panel will glow red while charging is
in progress, then turn green when charging is complete.
Mounting and Camera Connection
A mounting bracket is provided with the Solar Panel.
The bracket should first be screwed into the tree at a
point above the camera where the solar panel has a
unobstructed exposure to the sun for the longest part of
the day. With the swivel head firmly attached to the tree
bracket, connect the threaded bolt at the end of the swivel
head to the mounting socket (brass ¼" x 20) on the back
of the Solar Panel. Loosen the swivel head knob, then the
Solar Panel so that the solar cells are aimed at the sun.
Once aligned tighten both locking collars. Finally, attached
the supplied cable to both the solar panel and the camera
and tie up the slack.
Note: There are two cables with different connectors, so
choose the connector that fits your model of camera.
5