Daewoo DTC-240 Manuel D'instructions page 11

4. Or press or HOLD/RING key to quit hold mode and talk at hands-free mode.
TWO TOUCH MEMORY OPERATION
 Store the number in two-touch memory
4. Pick up the handset or press
you hear "di" sound.
5. Dial the phone number you want to store, press MEMORY key again.
6. Press numerical key (0-9).
 Make a call from one-touch memory
Pick up the handset or press
stored number out.
FLASH FUNCTION
When dial a number and the line is busy, press R and REDIAL/P key to dial it out again.
To change the flash time among 100ms, 300ms, 600ms, slide the FLASH switch at the
corresponding location。
TRANSFER CALL FUNCTION
To transfer a call during a conversation to another phone number, press R key and dial the
desired destination number. When you hear the tone signal return the handset to the base to
finish the call transfer.
MUTE FUNCTION
When making a phone call, if you need a temporal talk with someone else and you don't want the
phone receiver hear your speaking, press MUTE key to mute your voice sending.
Press MUTE key again to return to conversation mode.
PAUSE
When dialing, press REDIAL/P key to insert a 3.6s pause time between dialed numbers.
ADJUSTING RINGING TONE AND RINGING VOLUME
At on-hook state, press HOLD/RING key to enter to ringing tone adjustment.
Then press numerical keys to adjust, the telephone will play the relevant ringer and volume. The
operation as follows:
1. The first group ringing tone in the numerical keys: "1", "4", "7", and "1" stands for the
minimum volume, "4" stands for the middle volume, "7" stands for the maximum volume.
2. The second group ringing tone in the numerical keys: "2", "5", "8", and "2" stands for the
key, then press and hold MEMORY key for 3 seconds until
key, then press MEMORY and numerical key (0-9) to dial the
11