PSI Woodworking Products PKSKULL Serie Mode D'emploi

#PKSKULLXX
Skull Twist Pen Kit
Kit Features:
• Easy to turn with straight tubes
• Minimum parts - easy to assemble
• Available in multiple finishes
• Uses Parker® Style refill
• Attractive cast and etched components
• Overall Length: 6"
Required Accessories:
• 7mm Pen Mandrel
• Drill Bit: 3/8" #PKEXEC-38
• Bushing set(3 pc): #PKSKULLBU
• Barrel Trimming set: #PKTRIM38
• Live Tailstock Center
• 2 Part Epoxy Glue or Insta Cure (Cyanoacrylate) Glue
• Pen Blank: Minimum Size - 3/4" x 3-1/2" L
Tip
Tip Nut
Spring
*WARNING: Do not press directly on threads
Preparing the Blank:
• Cut 2 blanks to the length of the tubes and add 1/16" for squaring off.
• Drill 3/8" holes lengthwise through the blanks.
• Spread glue over the tubes, insert the blank with a twisting motion to spread the glue evenly inside.
• Center the tubes lengthwise inside the blanks.
• When the glue is dry, square the ends of the blanks. Use a 3/8" barrel trimmer, or a universal pen blank squaring jig
with a power disc sander. Take the excess material down flush with the ends of the brass tube. (do not trim beyond
the length of the tube since this may interfere with operation of the mechanism and assembly). Use a barrel trimmer
to clean the inside of the tube.
DIAGRAM A / PARTS LAYOUT
Coupler*
1.710"
Lower tube/barrel
Protector
Mechanism
Band
Refill
PSI Woodworking Products
NOTE: alignment of band,
clip and cap
Upper tube/barrel
Cap Nut
1.36"
Cap
Clip