ASSEMBLY INSTRUCTIONS (CONTINUED)
9. Remove the film from the adhesive on the top of
the fireplace grate (O) and place the fire log (N)
on the center of the fireplace grate (O).
Attach the USB cable from the heater into the
USB port behind the fireplace grate (O).
10. Insert the fireplace brick wall (L) into the
mantel, slotting it into the grooves on base and
heater (J). Secure with screwing three short
screws (DD) by Phillips screwdriver.
Hardware Used
Short Screw
DD
11. Screw four connecting rods (FF) into the
designated plastic bushings on the top of the
center shelf (D).
Hardware Used
Connecting Rod
FF
9
10
x 3
11
x 4
11
N
2
2
O
1
L
D
1
DD
FF