Be Cool tornado ifix Mode D'emploi page 22

EN
2 - INSTALLING WITH VEHICLE'S SEAT BELT
1. Place your child in the car seat and make sure they are sitting
well back.
2. Thread the vehicle's seat belt through the belt guide under the
headrest and the belt guide under the armrest.
2.1. Pass the diagonal section of the seat belt through the belt
guide under the headrest.
2.2. Pass the lap section of the seat belt through the seat belt
guide under the armrest next to the seat belt buckle.
2.3. Ensure that no part of the seat belt has become twisted or
trapped and that the car seat's fabric cover is not impeding the
movement or correct fitting of the seat belt.
3 - INSTALLING THE CHILD CAR SEAT
3. Ensure that the diagonal belt lies gently on the child's
shoulder and the lap belt is worn over the hips Tighten the
diagonal section of the seat belt by pulling it upwards until
there is no slack and the belt holds the child firmly in place.
4. To take the child out of the seat, simply unfasten the seat belt
and undo the shoulder belt guide.
4 - USE THE ISOFIX SYSTEM IF YOUR VEHICLE'S
SEAT HAS ADDITIONAL ISOFIX ANCHOR
If your vehicle is equipped with Isofix anchor points, these should
be used to obtain a more stable installation.
22
These cars will have plastic elements that guide the seat's Isofix
IM 2013,01 TORNADO_IFIX ins OK.indd 22
anchors into their correct positions. If your vehicle does not have
these guide elements, you can use the plastic guides provided
with the car seat.
Caution: When the seats of your car are equipped with Isofix
anchor points, install your car seat using your vehicle's ISOFIX
anchor points ALWAYS and ONLY in combination with the car's
safety belts. See the vehicle list.
Match the back rest hook to the rear side of base from lying
position to upright position, to make sure the back rest is fully
matched into the base.
1. Place the car seat in the appropriate position on the vehicle's
seat, facing in the direction of travel.
2. Rotate the adjuster button in anti-clock wise direction, and
simultaneously pull the isofix connectors outwards as far as it
goes, make sure it cannot be push backwards.
3. Position the car seat facing forwards on the vehicle seat with
ISOFIX points.
4. Match the ISOFIX connectors to the vehicle's anchoring point
until hear a "click".
5. Rotate the adjuster button in anti-clock wise direction, and
simultaneously push the seat against the vehicle to eliminate
the gap between car seat and vehicle's seat.
ATTENTION! ISOFIX connectors are an additional fitting system
for securing the car seat and not suitable for securing a child.
Child must always be secured by means of the car's three-point
safety Belt.
19/6/18 19:24