Bahco BCL31SD1 Instructions D'utilisation page 9

Battery Pack LED Indication Function (Optional)
The Battery Pack has a "SW" button and 4-step green LEDs for indicating remaining capacity status.
The fuel gauge green LED will indicate when the "SW" button is momentarily pressed.
Remaining Capacity LED Indication
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
LED 1, 2, 3, 4 (green)
WARNING
1. C harger is plugged into a 100-240V a.c outlet only.
2. If the battery pack is too hot or too cold, the charger will not fast charge the battery pack and the red
Indicator light is "blinking". When the battery pack temperature returns to between 0°C (32°F) and
50°C (122°F), The charger will automatically begin charging.
3. If both red and green indicator lights are "ON" the battery pack either does not comply or is
defective. Please contact your retailer.
4. Do not charge the battery pack in the rain, snow or high temperature environment.
5. D o not charge battery pack when environment temperature is below 0°C (32°F) or above 40°C (104°F).
6. W hile charge the cool battery pack (below 0°C) in the warm indoor, keep the battery pack in the
room for one hour to warm up before starting the battery pack.
7. R emove the plug after finishing the charge.
8. The charger should be cooled at least one hour after continue charging three times.
9. Do not use generator for charging the battery pack.
8. TOOL OPERATION
Attaching the Bits (Bits excluded)
1. Insert the bit into the hole of the driver shaft.
2. To remove the bit, pull it out from the bit holder.
RC Status
0% - 25%
26% - 50%
51% - 75%
76% - 100%
9.5 mm (3/8") - 11.5 mm (7/16")
• •
9
6.35 mm (1/4")