Maintenance; Transportation And Storage; Resolving Problems - Ecotap DC 30 Manuel

19.4 Insert the cable and attach the strain relief
Insert the power cable at the bottom and
tighten the cable gland.
Attach the cable to the provided strain relief
bracket inside the charger.
Connect the cable wires to the terminals of
the main switch
(max. 5Nm).

20. MAINTENANCE

Always disconnect the charging station from the power supply and read the
manual before performing maintenance or fixing a malfunction.
Only products approved by the supplier can be used to repair or replace components.
Repairs and replacements should always be carried out by a certified specialist.
Maintenance should always comply with and be carried out in accordance with NEN3140
and NEN50110 low voltage EU regulations.
Check the charging station for leaks.
Check the wires of the main power cable and ensure a tight connection of at least 3.5 to 5
Nm.
Treat any damage to the charging station with anti-corrosion paint.

21. TRANSPORTATION AND STORAGE

The charging station must be transported in a flat position in its box in order to prevent
damage to the paint. Damage to the paint can lead to corrosion.
The charging station should be stored in a dry area.

22. RESOLVING PROBLEMS

If the charging station is not functioning properly, please contact the back office provider or
contact another certified mechanic with the right measuring and testing equipment with car
simulation.
22. www.ecotap.nl
20-04-22