Publicité
Les langues disponibles
Les langues disponibles
ALARM
SETTING/ADJUSTING DUAL ALARM TIME
You can set two alarm times (AL1 and AL2).
1. Press the [
] button to display Alarm 1.
2. Press and hold [
mode for the currently selected alarm (Alarm 1).
3. The setting parameter will flash.
4. Press [ ] or [ ] button to set the desired data.
5. Press [
] button to confirm setting and enter to
next parameter.
6. Sequence of setting: Hour Minute Exit
7. The alarm will sound when the alarm setting is
finished and turned on.
8. If there is no action in 20 seconds, the setting will be
saved and will exit the setting mode.
TURN ON/OFF ALARM
1. In alarm display mode, press the [
turn on/off the current alarm. when in calendar
display mode, the sequence is: AL1 on AL2 on
AL1+AL2 on AL1+AL2 off.
10
] to enter the alarm setting
] button to
2. The alarm lasts 2 minutes and becomes faster and
faster over time.
OPERATION
1. At the set time, alarm signal rings.
2. During the alarm, press the [
delay the alarm by 8 minutes.
3. If you do not press any button to stop the alarm, it
will automatically turn off after 2 minutes.
4. To stop the alarm, press [
except SNOOZE.
5. The alarm will start again at the next alarm time,
unless you switch off the alarm function by pressing
the [
] button.
PROJECTION
The projector displays the time or temperature on your
ceiling or wall and it can rotate 180°. It is easier to view
in a darkened room. For the optimal projection results,
place the unit within 1.5 - 2 m (5-6.5 ft) from the ceiling
or wall.
] button to
] or any other button
Publicité
