Grizzly Tools EKS 1835-3 Traduction De La Notice D'utilisation Originale page 41

of the log not sawed through is
designated as a break dimen-
sion .
Slide a cutting wedge or crow-
bar into the felling cut as soon
as the cutting depth so permits,
in order to prevent the blade
from getting jammed. When
the felling cut nears the hinge,
the tree should begin to fall. If it
becomes apparent that the tree
might not fall into the desired
direction or if it bends back, and
if the chainsaw is stuck, dis-
continue the felling cut and use
wooden, plastic or aluminium
wedges to open the cut and fell
the tree to fall into the desired
fall line.
5. If the trunk diameter is larger
than the length of the chain bar,
make two cuts.
For safety reasons, we advise
inexperienced users not to fell
any logs with a rail length which is
smaller than the trunk diameter.
After carrying out of the back cut, the
6.
tree falls by itself or with the aid of the
felling wedge or crowbar. .
As soon as the tree begins to
fall, pull out the saw from the
section, stop the motor, place
the electric chainsaw down and
leave the workplace using the
withdrawal path.
Be completely aware of the fall-
ing cut material
Maintenance and
cleaning
Basically, carry out mainte-
nance and cleaning works with
switched-off motor and power
plug removed. Danger of injury!
Leave any maintenance and ser-
vicing work not covered by this
manual to our Service-Center.
Use only original spare parts.
Allow the machine to cool down
before all maintenance and
cleaning works. Danger of burn
injuries!
Maintenance intervals
Regularly carry out the maintenance oper-
ations listed in the following table. The life
of the saw is extended by regular main-
tenance of your chainsaw. Furthermore,
you get optimum cutting performance and
avoid accidents.
GB
41