Publicité
Les langues disponibles
Les langues disponibles
Teeth of the sprocket chain wheel .......... 6
Sawing length ......................max. 350 mm
Length of the chain bar ................ 420 mm
Sound pressure level
(L
) ..................91.5 dB(A); K
pA
Sound power level (L
measured .... 103.4 dB(A); K
guaranteed ............................ 106 dB(A)
Vibration a
... max. 5.79 m/s
h
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under
actual usage conditions (all parts
of the operating cycle are to be
considered, including, for example,
times during which the power tool
is turned off and times when the
tool is turned on but is running
idle).
This device is designed for opera-
tion on a power supply network
with a system impedance Zmax
at the transfer point (domestic
connection) of a maximum of
0.335 Ohms. The user must en-
sure that the device is operated
only on a power supply network
= 3.0 dB
pA
)
WA
= 2,55 dB
WA
; K= 1.5 m/s
2
that fulfils this requirement. If
necessary, the local power supply
company can be asked for the sys-
tem impedance.
Safety information
This section describes the basic safety
rules when working with the device.
2
Before working with the electrical
chainsaw, familiarise yourself with
all the controls. Practise handling
the saw (by cutting logs to size on
a sawhorse) and have the func-
tionality, mode of action, sawing
techniques and personal safety
equipment explained to you by an
experienced user or an expert.
Symbols on the device
Observe! Danger!
Read and take note of the operat-
ing manual belonging to the ma-
chine!
Wear personal protective
equipment. Basically, wear
protective goggles or, even
better, face protection, safety
helmet, cut-protection work-
ing clothes, cut-protection
gloves, cut-protection safety
boots with anti-slip soles and
ear protection.
Caution! Spring-back - Be careful
of spring-back of the machine dur-
ing work.
Always use the chainsaw with
both hands.
GB
29
Publicité
