LENCO SB-040 Mode D'emploi page 12

All manuals and user guides at all-guides.com
2: Short press
control to turn on the soundbar. The indicator of the last
used mode will light up.
3: Press the source button on unit or Remote Control to
choose various source. The color of the indicator light
will change as per selection.
Note: The Soundbar will re-enter the Standby Mode
again if there is no operation for 15 minutes.
Bluetooth Pairing:
1: Press the Bluetooth button on the Remote control to
enter the Bluetooth mode. You can also short press the
Source button on the Soundbar to choose the Bluetooth
Source.
2: The indicator light will flash in blue.
3: Turn on the Bluetooth function on your devices and the
device will start to search for the Soundbar.
4: Select "Lenco SB-040" from the list of found devices.
5: If asked, enter the password "0000" and press OK.
6: When successfully paired with your device, the indicator
light will be lit steadily.
Note: The Bluetooth playback is controlled by your
device and the buttons on the remote control.
Note: The operation range for the Bluetooth connection
is 10 meters.
Note: If a mobile phone on which you are playing music
receives a call, the music will be interrupted and not
played. After call end, the devices are connected to each
other again and playback continues.
7: Press and hold the Bluetooth button on the Remote
Control for 3 seconds to disconnect the Bluetooth
pairing.
/SOURCE on unit or
9
on remote