MCS BC 60 Manuel D'utilisation Et De Maintenance page 7

►►6. TROUBLESHOOTING
FUNCTIONING
ANOMALIES
The display doesn't
work
No air flow or too low
The device does not
respond to commands
The device leak water
Figures and texts of this book are protected by COPYRIGHT.
CAUSES
1. No power supply
2. Defective equipment
1. Obstruction of the air intake
on the back
2. Defective equipment
1. Defective equipment
1. The drain cap is loose
2. The drain is dirty and the cap
doesn't fit
3. The tank leak
4. The panel drip
SOLUTIONS
1a. Check whether the device is
connected to power supply
1b. Contact service point
2. Contact service point
1a. Keep the back side far from
walls that can block air inlet
1b. Remove objects from inlet
air section
1c. Contact service point
2. Contact service point
1. Contact service point
1. Close the drain cap
2. Clean the drain and close the
cap
3. Contact service point
4. Contact service point
en