MCS BC 60 Manuel D'utilisation Et De Maintenance page 5

►►2. UNPACKING
►2.1. Remove all packaging materials
used to wrap and deliver the appliance
and dispose of them in compliance with
the Standards in force.
►2.2. Extract all items from the packaging.
►2.3. Verify if damage undergone during
transport. If the
damaged, inform the dealer, where the
purchase was made, immediately.
►►3. ASSEMBLY
The device is equipped with wheels to
facilitate handling. Depending on the model,
wheels can be found already installed or not.
Components equipped with relative nuts
and bolts are found inside the packaging
(Fig. 1).
►►4. OPERATION
WARNING: Thoroughly
"INFORMATION REGARDING SAFETY",
before switching the appliance on.
WARNING: Only use clean water to
prevent failures or other anomalies.
WARNING: Verify if your electronic
system is earthed correctly. Connection
to the mains must be made in compliance
with the National Standards in force.
Power the appliance only with voltage
and frequency as specified on the data
plate.
NOTE: These models can be connected
to the water mains, by connecting the
pipe to the fitting (Fig. 10).
►►4.1. SWITCHING ON:
►4.1.1. Open the tank door (Fig. 2).
►4.1.2. Fill the tank with water (Fig. 3);
water level must be within MIN and MAX
level of the graduated scale, placed at the
side of the appliance (Fig. 4), in order to
prevent risks.
►4.1.3. Close the tank door (Fig. 5).
►4.1.4. Connect the power plug to the
mains (Fig. 6).
►4.1.5. Press the ON/OFF button to switch
on the appliance (Fig. 9).
Figures and texts of this book are protected by COPYRIGHT.
appliance appears
read the
►►4.2. CONTROL PANEL, USE
AND FUNCTIONS FOR MODEL BC
60 (Fig. 7-8):
►ON/OFF: It allows switching ON or OFF
the appliance.
►SPEED: Allows increasing or decreasing
the appliance ventilation speed. Three
speeds can be selected - LOW, MID and
HIGH.
►COOL: It enables or disables the cooling
mode.
►SWING: It enables or disables the
automatic vertical oscillation of the flaps
to direct the air flow.
►ANION: It enables or disables the
ionisation mode, i.e. release of negative
ions into the environment, in order to
make air healthier.
►TIMER: It enables or disables the timer
of the appliance automatic switch-OFF.
Intervals can be of half-hour up to 12
hours.
►►4.3. CONTROL PANEL, USE
AND FUNCTIONS FOR BC 180 (Fig.
7-8):
►ON/OFF: It allows switching ON or OFF
the appliance.
►COOL: It enables or disables the cooling
mode. Pay attention to the fact that the
fan is switched on one minute after the
initiation of wetting of the cooling panel
with water.
►BLAST: Pressing the COOL button
again switches off the water vaporization
function, and only the fan is in the operating
mode.
►SPEED: Allows increasing or decreasing
the appliance ventilation speed. Three
speeds can be selected - LOW, MID and
HIGH.
►SWING: It enables or disables the
automatic vertical oscillation of the flaps
to direct the air flow.
►TIMER DELAYED
the commencement of the operation
of the device with a delay, after several
hours. When the green light -POWER- is
switched on only, press the TIMER until
the required number of hours of delay (1-
24) appears.
en
START: Enables