To Select Vacuum Cleaning Mode; Maintenance; To Remove Dust From The Dust Container And Clean The Filters; To Clean The Side Brushes - Menuett 008164 Instructions D'utilisation

2
Push the On/Off button on the remote control.

3.5 To select vacuum cleaning mode

1
Start the product. Refer to "3.4 To use the product" on
page 26.
2
Push the mode setting button on the remote control
to select vacuum cleaning mode.
3.5.1 Automatic vacuum cleaning
● Push the mode setting button on the remote control to
select automatic vacuum cleaning. (Figure 10)
3.5.2 Spot vacuum cleaning
● Push the mode setting button on the remote control to
select spot vacuum cleaning. (Figure 11)
3.5.3 Random vacuum cleaning
● Push the mode setting button on the remote control to
select random vacuum cleaning. (Figure 12)
3.5.4 Edge vacuum cleaning
● Push the mode setting button on the remote control to
select edge vacuum cleaning.
● The product uses a brush to clean edges. (Figure 13)
3.5.5 Zigzag vacuum cleaning
● Push the mode setting button on the remote control to
select zigzag vacuum cleaning.
● Zigzag cleaning is suitable for a large surface with no
furniture. (Figure 14)
4

Maintenance

4.1 To remove dust from the dust
container and clean the filters
1
Push the symbol on the lid to open it.
(Figure 15–16)
2
Remove the dust container from the product.
(Figure 17)
3
Remove the HEPA filter. (Figure 18)
4
Remove the primary filter. (Figure 19)
5
Remove the dust from the dust container. (Figure 20)
2022_001
6
Clean the dust container with water. (Figure 21)
7
Clean the primary filter with water after 15–20 days of
operation. The primary filter can also be cleaned with
the cleaing tool (included with the product). (Figure
22)
8
Let the primary filter become dry.
9
Clean the HEPA filter with the cleaning tool. The
HEPA filter must be replaced after 24 months.
10
Install the HEPA filter and the primary filter in the dust
container. (Figure 23)
11
Close the lid.
Caution! Do not expose the filters to direct sunlight.

4.2 To clean the side brushes

1
Examine the side brushes for damage and unwanted
materials in the brushes.
2
Clean the side brushes with a cleaning tool or a cloth.
3
Replace the side brushes if they are damaged. Refer
to
4
5
4.2.1 To replace the side brushes
1
Pull off the old brush from the product.
2
Install a new brush on the product.

4.3 To clean the product

1
Carefully wipe the sensors and wheels with a
cleaning tool or a soft cloth. (Figure 24)
2
Clean the charging terminals on the charging station
with a cleaning tool or a soft cloth. (Figure 25)
3
Clean the vacuum port with the cleaning tool or a soft
brush. (Figure 26)
27