To Use The Remote Control; To Charge The Battery; To Use The Product - Menuett 008164 Instructions D'utilisation

● Move furniture to prevent that the product gets stuck.
● Remove power cords and objects from the floor.
● Use a step guard to prevent that the product falls down
from stairs.
● Make sure that the dust container is empty before you
operate the product. Refer to "4.1 To remove dust from the
dust container and clean the filters" on page 27.
● Make sure that the ambient temperature in the work area
is 0–40°C.

3.2 To use the remote control

The remote control is used to change the settings on the
product.
1
Push the On/Off button on the product to start the
product. The product is now in standby mode.
2
Push the On/Off button on the remote control to
activate the remote control.
3
Push the On/Off button on the remote control again
to activate the product.
4
Push the direction buttons to select the direction for
the product.
5
Push the charging station button to move the product
to the charging station.
6
Push the mode settings button to activate vacuum
cleaning mode.
7
Push the mode settings button again to change the
type of vacuum cleaning mode.
8
Push the high power button to start high power
cleaning.
9
Push the On/Off button on the product or the On/Off
button on the remote control to pause the product.
10
Press and hold the On/Off button on the product or
the On/Off button on the remote control for 3s to set
the product to Standby mode.
11
To activate the product,
A. Press and hold the On/Off button on the product.
B. Press and hold the On/Off button on the remote
control within 15 minutes from when the product
was put in standby mode.
26

3.3 To charge the battery

Note! Let the battery become completely discharged the
first time you use the product. After that, always make sure
to charge the battery when the battery level is low.
1
Put the charging station in front of a wall. Make sure
that there is 1 m of free space on each side (A), and 2
m of free space in front (B) of the charging station.
(Figure 7)
2
Push the On/Off button on the product.
3
Push the On/Off button on the remote control. A blue
light flashes and the product is in standby mode.
4
Connect the mains adapter to the product. (Figure 8)
5
Connect the mains adapter to the charging station.
Push the charging station button on the remote
control. A red light flashes when the product is
charged. After 5 hours when the charging is
complete, the charger makes a sound 5 times. (Figure
9)
3.3.1 To charge automatically
● When the vacuum cleaning is finished, or when the
battery needs to be charged, the product moves to the
charging station.
Note! The product can only find the charging station if the
charger station has power.

3.4 To use the product

Note! Make sure that the dust container is installed.
3.4.1 To use the product with a dry cloth
1
Push the On/Off button on the product.
2
Push the On/Off button on the remote control.
3
Put the cloth fastener and the cloth on the base of the
product.
4
Put the product on the floor and push the On/Off
button on the remote control.
3.4.2 To use the product without a dry cloth
1
Put the product on the floor and push the On/Off
button on the product.
2022_001