Publicité
Les langues disponibles
Les langues disponibles
G
B
ROLLING SHUTTER WITH LENGHT SHAFT OVER 4 m
In this case we suggest to mount 2 JOLLY on the same shaft at the shutter extrimities. It is
necessary to eliminate the limit switch of one of the 2 JOLLY and connect in parallel the two
motors.
JOLLY without limit switches
=
IMPORTANT
3 wires cable to connect the two operators
IMPORTANT!
When mounted with engine on the left all the operations are inverted and limit
switch F1 becomes F2
1 - Cam which stops travel pressing the limit switches
2 - Screw to block the limit switches
F1 - Screw to adjust the limit switch which stops the upward movement
F2 - Screw to adjust the limit switch which stops the downward movement
To adjust the electric limit switches tighten the two blue screw and unscrew or tighten the
wheels F1 and F2.
To maintain the desired position of the switches, you must block the two screws when the
adjustment is done.
ATTENTION:
Avoid all the manouvres of the motor really not necessary during
the regulation. Many manouvres at the same time cause the
intervention of the thermal sensor.
Short travel => Tighten F1
ADJUSTMENT OF THE LIMIT SWITCH WHICH STOPS THE DOWNWARD MOVEMENT
Ground
ADJUSTMENT OF THE LIMIT SWITCH WHICH STOPS THE UPWARD MOVEMENT
Short travel => Unscrew F2
IMPORTANT: Before fixing the two pulleis to the shutter laminate (4), verify that the sense of
rotation of the 2 JOLLY is the same.
SPRINGS
Ground
Long travel => Unscrew F1
Long travel => Tighten F2
24
JOLLY with limit switches
=
IMPORTANT
Ground
Correct adjustment
Tighten the 2 blocking screw
Correct adjustment
Tighten the 2 blocking screw
4
5
6
7
Publicité
