Publicité
Les langues disponibles
Les langues disponibles
8338089
OPERATION
WARNING! Make sure no persons or animals are under the ramps or tailgate during the
loading process.
LOADING A MOTORCYCLE
NOTE: It is recommended to use 3 people for loading
1.
Ensure the tongue (#2) edge is face down, as shown in the Parts Breakdown section, in order to
contact fully with the tailgate of the truck.
2.
Put the motorcycle in neutral.
3.
Position a person on each side of the motorcycle. Each person should hold either the front
handlebar or the front fork in order to steer/guide the vehicle. They should position their other
hand toward the rear of the seat or the rear fork.
4.
The third person can start loading by pushing from the back, then move to the inside of the
truck bed to take control of the motorcycle when it enters the truck bed.
5.
As the motorcycle contacts the ramp, ensure the ramp remains straight and the tongue edge
remains in contact with the tailgate. If not, roll back slowly and start over.
LOADING AN ATV
NOTE: It is recommended to use 3 people for loading
1.
Position the ramps to match the width of the ATV wheels.
2.
Ensure the tongue (#2) edge is face down, as shown in the Parts Breakdown section, in order to
contact fully with the tailgate of the truck.
3.
Put the ATV in neutral.
4.
Position a person on each side of the ATV. Each person should have one hand on the handlebar
and the other hand on the rear rack.
5.
The third person can start loading by pushing from the back.
6.
As the ATV contacts the ramps, ensure the ramps remain straight and the tongue edges remain
in contact with the tailgate. If not, roll back slowly and start over.
LOADING A DOLLY WITH AN APPLIANCE
NOTE: It is recommended to use 3 people for loading
1.
Position the ramps to match the width of the appliance wheels.
2.
Ensure the tongue (#2) edge is face down, as shown in the Parts Breakdown section, in order to
contact fully with the tailgate of the truck.
3.
Position people according to the needs of the particular appliance.
4.
As the dolly wheels make contact with the ramps, make sure the ramps remain straight and the
tongue edges remain in contact with the tailgate. If not, roll back slowly and start over.
Visit www.princessauto.com for more information
2 pc Rugged Tread Steel Ramps
V 2.8
5
Publicité
