Troubleshooting - Rotel U1432CH Mode D'emploi

• TROUBLESHOOTING

o Nothing happens when the power cord is plugged into the appliance.
 Make sure the power cord is not damaged.
 Make sure the power cord is correctly plugged into the electrical outlet and ap-
pliance.
o Appliance is plugged in, but cannot vacuum.
 Ensure the lid is properly closed.
 Ensure the open end of the bag is correctly placed into the vacuum chamber.
 If the indicator lights are flashing, the appliance may overheat. Allow it to cool for
several minutes before using it again.
 Check if the bag is punctured.
 Check if the foam sealing gasket is deformed or damaged.
o Air is removed from the bag, but re-enters.
 Check if there is a hole or puncture in the bag. It may be punctured by sharp items.
Use a new bag if necessary.
 Check the sealing seam. Any wrinkle along the sealing seam may cause air to re-
enter. If yes, simply cut the sealed edge and re-seal.
 If there is moisture or liquid at the open end, cut the bag and wipe it dry. Then
choose MOIST FOOD setting and reseal.
 If the food has been stored for a long time and the bag is full of gas, it may spoil
and should be discarded.
o Note:
 To prevent the appliance from overheating, allow it to cool for 60 seconds be-
tween uses. Keep the lid open to accelerate heat dissipation.
 If the bag melts, the sealing strip may overheat. Allow the appliance to cool for
60 seconds before using it again.
 For best results, do not reuse the bags after storing raw meat, fish or greasy foods.
Do not reuse the bags after simmering or microwaving.
o NTC Thermistor-temperature sensor:
 Smartly monitors the temperature of the appliance. Protection mode will be ac-
tivated automatically when overheating, the lights will flash and the appliance
will stop operating. The appliance will return to normal mode once cooled and
the lights stop flashing.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
42