Bond 68149 Guide D'utilisation page 8

ASSEMBLY INSTRUCTIONS
4. Remove the preassembled M5 screws from
the upper supporters (I), then slide the 3 upper
supporters into the slots at the top of the
burner (C). Once fully inserted secure the upper
supporters (I) into the burner (C) by replacing the
I
M5 screws that were removed at the beginning of
this step.
Note: Be sure that the hooks on the upper
supporters (I) are facing upwards.
C
5. Align the holes at the bottom of the burner (C)
to the top of the tank housing (D) - position to
have the control panel on the burner (C) aligned
with the door on the tank housing (D). Through the
BB
aligned screw holes attach the burner (C) to the
top of the tank housing (D) using 4 M6 x 12
screws (BB) and 4 M6 nuts (DD). Be sure to fully C
DD
tighten.
6. Remove the 3 preassembled screws from the
top of the burner (C). Attach the glass tube ring
(B) to the top of the burner (C) using the 3 screws
removed at the beginning of this step. Be sure to
fully tighten.
B
Bond Manufacturing Company | Page 8