Toparc 059955 Notice Originale page 6

Translation of the original instructions
EN
PORTABLE TRIPOD LAMP 250L
OPERATING INSTRUCTIONS
NOTE: Each LED flashlight is equipped with the dedicated ON/OFF Push Button and can be operated independently
without being assembled with other LED flashlights.
LED HIGH MODE: Press the ON/OFF switch, the work light will turn on. In this mode the work light operates as a maximum illu-
mination. Working time in this mode is up to 1 hour on a full charge.
LED LOW MODE: Press the ON/OFF switch one more time, the work light will turn on with a low light mode, working time in this
mode is up to 3 hours on a full charge.
LED WARNING MODE: Press the ON/OFF switch again, the LED light will blinking with warning light mode.
Press the ON/OFF switch one more time, the light will turn off.
IMPORTANT NOTE: Always turn the switch to OFF the light when the work light is not being used or during storage.
CHARGING INSTRUCTIONS
This 3 in 1 rechargeable led work light must be fully charged before being used for the first time as soon as taken
from the package. The battery should be recharged every three months.
This will ensure that the battery gives its best performance now and on future re-charging cycles. The AC and DC charging adap-
ters are for re-charging the battery only. They can not be used to directly power the light. Always ensure the light is switched off
while charging.
IMPORTANT NOTE : USE THE SUPPLIED CHARGER ONLY, OTHER CHARGERS MAY CAUSE THE DAMAGE TO THE UNIT.
USING THE AC CHARGING ADAPTER
1. Put the light vertically into the base. Plug the adapter's jack plug into the socket of the base.
2. Plug the adapter into a 120V socket and switch the socket on(if applicable).
3. The 3 charge LED indicators will glow RED while charging is in progress.
4. The battery will be fully charged after approximately 4-6 hours, and 3 RED charging indicator will be turned to GREEN when the
unit is fully charged.
5. Disconnect the jack plug from the light, remove the adapter from the wall socket or switch off.
TO PREVENT OVERHEATING DO NOT CHARGE FOR MORE THAN 8 HOURS.
SAFETY PRECAUTIONS
Use provided charging adapter indoors in a dry location only. Exposure to damp or wet conditions could cause electrocution or
damage to adapter.
Do not use the charger in the vicinity of flammable liquids or materials.
Store in dry location and do not allow the charging adapter to come in contact with water, rain or snow.
If the charging adapter comes into contact with water, place in a dry location at room temperature, on a soft absorbent towel and
allow to dry thoroughly.
Do not operate the unit until it is completely free of moisture.
Use only the AC charging adapter supplied with light. Do not attempt to charge the light with an adapter that is not compatible as
this could result in a fire, damage to the light or personal injury.
USING THE DC CHARGING ADAPTER
1.Put the light vertically into the base. Plug the adapter's jack plug into the socket of the base.
2.Plug the adapter into the vehicles 12V DC cigarette lighter or accessory power socket.
3.The 3 charging indicator lamp will glow RED while charging is in process.
4. The battery will be fully charged after approximately 4-6 hours, and 3 RED charging indicator will be turned to GREEN when the
unit is fully charged.
6
5.Disconnect the jack plug from the light, and remove the DC adapter from the outlet socket.