Bradley Halo S19224 Serie Installation page 4

S19224
Supplies Required:
• (4) ¼" anchors and bolts
• Teflon tape and pipe sealant
• 30 PSI (2 .0 bar) min/90 PSI (6 .1 bar) max flow pressure
• 125 PSI (8 .6 bar) max static pressure
• Piping to ½" NPT (BSPP) water supply inlet (30–90 psi [2 .0-6 .1 bar])
• Piping to 1¼" NPT drain outlet on unit (if included with unit)
• OPTIONAL: sign-mounting hardware
• DVGW certified teflon tape (for DVGW certified models only)
Local codes may require the installation of a backflow prevention valve to complete proper installation.
Compliance with local codes is the responsibility of the installer. Valve must be tested annually to verify that it
is functioning properly. Backflow prevention valves are not included with the fixture and may be supplied by the
contractor or purchased from Bradley Corporation.
4 8/5/2015
Bradley • 215-1686 Rev. N; ECN 15-05-019
Installation