Publicité
Les langues disponibles
Les langues disponibles
Product Safety Information
Intended Use:
These Air Orbital Sanders are designed for smoothing and sanding paint, fiberglass, wood and
body filler.
For additional information refer to Product Safety Information Manual Form 04580387.
Manuals can be downloaded from ingersollrandproducts.com
Product Specifications
Free
Speed
Model(s)
rpm
4151
12000
4151-2
12000
4151-5
12000
4152
12000
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16577215 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Regulator
2. Emergency shut-off valve
3. Hose diameter
4. Thread size
5. Coupling
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
04576005_ed17
Pad Diameter
inch
mm † Pressure (L
6
152
6
152
5
127
6
152
WARNING
6. Safety Air Fuse
7. Grease - Remove sanding pad and inject
8. Air Filter
9. Oil
10. Lubricator
Sound Level dB (A)
(ISO15744)
) ‡ Power (L
p
81.6
92.6
81.6
92.6
81.6
92.6
81.6
92.6
* K = Vibration measurement uncertainty
EN
Vibration m/s²
(ISO28927)
)
Level
*K
w
7.5
1.6
6.2
1.0
6.2
1.0
8.2
1.7
EN-1
Publicité
