Publicité
Les langues disponibles
Les langues disponibles
procedure does not damage the battery.
The lithium-ion battery is protected against deep
discharging. When the battery is empty, the machine
is switched off by means of a protective circuit: The
inserted
tool no longer rotates.
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot
be subject to overload. When the load is too high or
the allowable battery temperature range of 0–50 °C is
exceeded, the speed is reduced. The power tool will
not run at full speed until reaching the allowable battery
temperature. position. Unintentional actuation of the On/
Off switch can lead to injuries.
Open the keyless chuck 2 by turning in rotation
direction, until the tool can be inserted. Insert the tool.
Firmly tighten the collar of the keyless chuck 2 by hand
in rotation direction . This automatically locks the drill
chuck.
The locking is released again to remove the tool when
the collar is turned in the opposite direction.
2_FUNCTIONAL DESCRIPTION
PRODUCT FEATURES
1
1 Dust protection cap
2
2 Locking sleeve
3
3 Depth stop
4
4 Push-button for depth-stop adjustment
5
5 Impact stop switch
6
6 On/Off switch
7
7 Rotational direction switch
8
8 Battery
9
9 Battery unlocking button
10 10 Auxiliary handle
11 11 Clamping handle
INSERTING THE BATTERY
Set the rotational direction switch 7 to the centre position
(lock-off). Insert the charged battery 8 into the handle
until it can be felt to engage and is seated flush on the
machine.
SWITCHING ON AND OFF
To start the machine, press the On/Off switch 6 and
keep it depressed.
The machine runs with variable speed between 0
and maximum, depending on the pressure applied
to the On/Off switch 6. Light pressure on the On/
Off switch 6 results in low rotational speed, thus allowing
drilling to begin in a smooth, controlled manner. Further
pressure on the switch results in an increase in speed.
To switch off the machine, release the On/Off switch 6.
Do not strain the machine so heavily that it comes to a
standstill.
The machine is not suitable for stationary operation,
e.g., in a drill stand.
OVERLOAD CLUTCH
If the drill bit jams or edges, the drive to the drill spindle
is interrupted.
Due to the arising forces always hold the machine firmly
with both hands and provide for a secure stance.
Before pulling out a stuck tool insert, first remove the
machine from it.
REVERSING THE ROTATIONAL DIRECTION
Operate the rotational direction switch 7 only at a
standstill.
The rotational direction switch 7 is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch 6 actuated.
Right Rotation
Turn the rotational direction switch
through to the left stop (normal
operation: drilling, screwdriving,
etc.).
Left Rotation
Press the rotational direction
switch through to the right stop (for
loosening and unscrewing screws
and nuts).
IMPACT STOP SWITCH
Operate the impact stop switch 5 only when at a
standstill.
Set the impact stop switch 5 to the desired position:
Drilling
Hammer drilling
Hammer
BATTERY CHARGING
A battery that is new or has not been used for a longer
period does not develop its full capacity until after
approximately 5 charging/discharging cycles.
To remove the battery 8, press the unlocking buttons 9
and pull out the battery downwards. Do not exert any
force.
The battery is equipped with an temperature control
which allows charging only within a temperature range
of between 0 °C and 45 °C.
-
17
-
es
it
gb
de
fr
p
cz
el
Publicité
