Sound4you WBS20 Mode D'emploi page 17

2.Turn on both speakers as described above. Press and
hold the -button on either speaker for 2 seconds, and
the Status LED light will quickly flash blue and green
alternately. This speaker now serves as the main speaker
(MAS- TER) with playback on the left stereo channel. The
two loudspeakers then automatically connect to each
other. The second loudspeaker now functions as a slave
loudspeaker (SLAVE) with playback on the right stereo
channel.
Disconnect TWS connection
Press and hold the -button on either speaker for 2
seconds until the Status LED light flashes rapidly blue.
Connection via AUX input
1.Turn on the speaker as described above.
2.Use the supplied 3.5 mm jack cable to connect your
external device to the AUX-In connector of the speaker.
3.The speaker will automatically switch to AUX-In mode
and the Status LED light will turn steady green.
NOTE:
• In AUX-IN mode, the "Skip Songs" and "Handsfree"
functions are not available. In this mode, operation is
exclu- sively via the connected playback device.
• To return to Bluetooth® mode, simply pull the 3.5 mm
jack cable out of the socket on the loudspeaker.
Resetting the speaker
If you experience problems with the speaker, you can
easily reset it. To do this, disconnect it from the charger
cable and gently push a thin needle (diameter <3 mm)
into the RESET hole provided for this purpose for 2
seconds until the status LED light goes out. The RESET
hole is located on the back of each speaker next to the
AUX input.