Proscenic LDS D500 Mode D'emploi page 9

② Uncap the water tank, fill it with water, and fasten the
rubber cover.
·Some disinfectant or detergent may clog the tank filter
③ As shown in the figure, push the mopping module
horizontally into the bottom of the robot.Please make
sure the buckles on both sides are installed properly.
Press the buckles on both sides of the mop module
to remove the mopping modules.
·Please remove the mopping module while charging or not in service
Cleaning Cycle
Robot stars by scaning the house, generating a map for
the area and intelligently dividing the house into different
sections. In each section, the robot firstly cleans along
the wall, and then cleans in a zigzag pattern.The robot
completes the cleaning of each section in an efficient
and orderly way. When finished, the robot returns to
its base to get charged.
Vacuum Robot
42
㎡
Cleaning Area
Charging Clean
Charging
57% 38
min
Battery Level Clean Time
Quite Mode More
Pause / Resume Clean
1. As the figure a shows, in standby mode, press"
on the robot to start clean (Press any button to pause
cleaning ).
2. As the figure b shows, click the clean button in APP to
start clean (Click the pause button to pause the current
task)
Note:
·The robot vacuum is not recommend for cleaning liquids.
·If the power is less than 20%, the cleaning task will not be performed.
Please charge before starting the cleaning.
·Robot automatically shuts down when the battery is below 5%.
·Please put aside wires on the floor before cleaning to avoid power failure
or damage to furniture.
a
Note: If you move robot mid-cycle it will clear its map and create a new
one when you restart it.It will also be unable to return to its base.
Spot Cleaning
The robot cleans in a square area of 1.5X1.5m.The
robot enters spot clean mode via either of the
following methods:
a.When the user specifies a point on the map, the
robot will come near that point, and then centering
on that point, the robot starts cleaning.
b.Start spot clean mode by remote control.
Schedule Cleaning
Please use the APP to schedule cleaning.The robot will
start cleaning as scheduled,and return to base after
finishing cleaning.
Edge cleaning
The robot cleans along the walls, and it returns
to its charging base after the current task is fi-
nished.
08
"
Vacuum Robot
Charging
42 57% 38
㎡ min
Cleaning Area Battery Level Clean Time
Charging 清扫 Silent Mode More
b