Proscenic LDS D500 Mode D'emploi page 12

Product Specifications
HOST
Classification
Dimension
Weight
Power Rating
Rated Power
Working Current
Charging Base
Dimension
Output Rating
Rated Input
Rated Output
Input Frequency
Trouble Shooting
When an abnormality occurs during the running of the robot, the Clean button or the Recharge button flashes,and voice
prompts. Please refer to the table below for troubleshooting.
voice prompt
1, Please put back the
dust box and filter
2, Please move the rob-
ot to the horizontal gro-
und to start
3. Please check the fall-
arrest sensors and move
the robot to a new posi-
tion to start
4, Please clean the right
wheel
5, Please clean the left
wheel
Parameter
320mm*300mm*97mm
3.5kg
14.4V
46.08W
3.2A
152mm×100mm×47mm
14.4W
100-240V~
24 V—600mA
50/60Hz
Indicators
Clean button and Recharge button
blink:they will slowly blink three
times then quickly blink once.
Clean button and Recharge button
blink:they will slowly blink once
then quickly blink once.
Clean button and Recharge button
blink: they will slowly blink twice
then quickly blink twice.
Clean button blinks: it will slowly
blink once then quickly blink twice.
Clean button blinks: it will slowly
blink twice then quickly blink once.
Solution
Please try to replace the filter and confirm
that the filter and dust box are in place. If
the problem remains, please try to replace
the filter again.
The robot is tilted at startup, please put the
robot on the horizontal ground to restart;
The robot suspends. Please move it to anot-
her position and restart it ; Dirty fall-arrest
sensors may cause the fault, so please wipe
them with soft rag
The right wheel is entangled with garbage.
Please remove garbage.
The left wheel is entangled with garbage.
Please remove garbage.
11