Skytec 170.112 Mode D'emploi page 7

2. TRACK SKIP
Use the TRACK SKIP control to advance (
3. FRAME SEARCH
Press the search control (
Keep pressing the control, it will move rapidly with sound until you get the precise position.
4. PLAY/PAUSE
Press this button to start the playback from your desired point, and press it again to pause it. The LED
is lit during playback, and blinking in pause mode.
5. Set a CUE point
Press this button while the unit is paused to memorize the point. Each time the CUE button is pressed,
the playback will return and pause at this point.
6. PITCH CONTROL SLIDER
Move the cap toward +16 direction, the playback gets fast; move it toward -16 direction,
the playback become slow.
TROUBLESHOOTING
Symptom
Door can not be opened when the
OPEN button is pressed.
When playback is started, stops or
pauses immediately.
No sound
Sound is distorted
Hum
) or reverse (
or ) in pause mode to move by one frame per press;
Cause
Power plug is not connected properly.
* Disc is loaded upside down.
* Dust or dirt on the disc.
* Output cables connected unproperly.
* Audio mixer operated unproperly.
* Pin plugs or amplifier terminals are
dirty.
* Player is in pause mode.
* Incorrect connection.
* Pin plugs or amplifier terminals are
dirty.
Cable connected unproperly.
) to desired track.
Remedy
Correctly connect the plug.
* Load the disc with lable side up.
* Clean the disc and load it again.
* Connect the cable properly.
* Check the setting of audio mixer.
* Press the PLAY/PAUSE button.
* Connection with audio mixer to the
LINE INPUT terminals.
* Clean away the dirt.
* Firmly connect all audio plugs.