Publicité
8
NuQ PRO Series
11.
13.
¼" TS
14.
15.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
12.
MUSIC Group
MIDAS KLARK TEKNIK
TURBOSOUND BEHRINGER BUGERA
DDA
MUSIC Group IP Ltd.
© MUSIC Group IP
Ltd. 2015
music-group.com/warranty
16.
17.
2000
Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further
information about this or any other product, please visit our website at turbosound.com.
Unpacking the Loudspeaker
After unpacking the unit, please check carefully for damage. If damage is found, please notify your
supplier at once. You, the consignee, must instigate any claim. Please retain all packaging in case of future
return shipment.
System Requirements
The NuQ62 2-way loudspeaker operates as a passive system and requires only one amplifi er channel.
The input signal is divided between the low-frequency and high-frequency drivers internally with a
passive crossover.
NuQ82, NuQ102, NuQ122 and NuQ152 models are switchable passive / bi-amp 2-way loudspeakers.
Passive operation (full range or with a subwoofer) requires 1 amplifi er channel and 1 controller channel.
The input signal is divided between the low-frequency and high-frequency drivers internally with a passive
crossover. Bi-amp operation (full range or with a subwoofer) requires 2 amplifi er channels and 2 controller
channels, one for low frequencies one for high frequencies. The input signal is divided between the low
frequency and high frequency driver in the controller and the individual amplifi ed signals are fed to the
speaker input.
NuQ115B and NuQ118B subwoofers have a switchable input to allow operation with the satellite speakers
using a single four core cable run. Operation requires 1 amplifi er channel and a 1 controller channel.
Correct controller settings for all models operation and subwoofers can be downloaded from
turbosound.com, and are also available as presents for the LMS series controllers. To avoid wasting
amplifi er power, you should use heavy-duty speaker cable with a minimum wire size of 1.5 mm² (16 AWG),
and preferably 2.5 mm² (14 AWG) for longer runs. For extreme cable lengths, be aware of cable impedance
and resistive losses. Always observe the correct polarity.
All NuQ PRO 2-way systems double effectively as wedge monitors.
Quick Start Guide
9
Publicité
