External Control Via Signal Cable (Only 150B And 450B); Maintenance And Cleaning; Troubleshooting - proemit sunbar 150 Mode D'emploi

8.2

External control via signal cable (only 150B and 450B)

Insert the 3.5mm jack cable (mono) with the external DIM signal (0-10V, PWM or resis-
tor) into the DIM input of driver housing.
The LED grow light is now dimmed via the external DIM signal. The built-in driver
Turn knob is automatically without function when the jack cable is plugged in.

9. Maintenance and cleaning

The light does not contain components that must be serviced.
Only the complete device can be replaced.
CAUTION!
Use a lint-free, dry cloth.
Cleaning agents can contain aggressive substances that will damage
the surface. For cleaning purposes, the sunflow plant light must be
disconnected from the power supply.

10. Troubleshooting

The light cannot be switched on
1. Mains plug not connected to the power supply
-> Check the plug and insert it
2. External DIM cable inserted
-> DIM IN/OUT remove cable
The luminaire contains built-in LED arrays. The light source of this luminaire may only
be replaced by the manufacturer or a service technician appointed by him or a similarly
qualified person.
22