Product Description - proemit sunbar 150 Mode D'emploi

• Never look directly or with optical instruments into the light of the lamp's LEDs.
There is a risk of eye damage!
• If the lamp is damaged or is not working properly, it must not be operated any-
more, and the mains voltage must be switched off immediately. Request an autho-
rised electrician to inspect the lamp.
• Keep plastic and other packaging materials away from children. There is a risk of
suffocation.
• If the lamp is installed in commercial facilities, compliance with the accident
prevention regulations of the applicable standards of electrical associations of the
relevant country of installation is mandatory.

7. Product description

The sunbar grow light consists of a driver housing and a cable connected LED light. The
LED part consists of a generously dimensioned heat sink profile with three Cree High-
Power LEDs and wide-scattering lenses, connected to an aluminum electronics housing.
It is hung on two eyelets mounted in a groove. The driver housing is connected by plug
connection with the LED part and connected by means of power cord to the socket.
Variant 150 A can be dimmed by 50% using a internal potentiometer.
The variants 150 B and 450 B can be dimmed with the knob on the driver housing or
alternatively dimmed by an external DIM signal.
When installing the unit, compliance with instructions in the chapter "Safety instruc-
tions" is mandatory.
19