Publicité
Les langues disponibles
Les langues disponibles
Installation Guide
Wallplate installation
1. Separate wallplate from thermostat.
2. Mount wallplate as shown below.
Drill 3/16" holes for drywall. Drill 7/32" holes for plaster.
Wall anchors
CAUTION: ELECTRICAL HAZARD
!
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
!
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
Remove battery holder.
Pull here to remove wallplate
from new thermostat.
Wire hole
It's easier to grasp the wallplate
and remove it after completely
removing the battery holder.
Mounting screws
Wallplate
Publicité
