Hendi 221600 Mode D'emploi page 6

Operation
Warning: Make sure the appliance is unplugged from the electrical power supply & make sure the power
switch is at the "0" position.
• Pour the milk inside the cup. (Note: Do not put
too much to avoid overflow).
• Screw in the agitator.
NOTE: There are 2 single and 2 double layer for
selection. Use double layer agitator to allow more
air into the mix and create a smoother or bigger
froth of drink.
• Insert the cup with the ingredients on the cup
holder.
• Connect the power plug to a suitable electrical
power supply.
• The power switch has 2 speeds for selection.
Switch ON the appliance by turning the power
switch to the I (low speed) or II (high speed) po-
sition.
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning & storage.
EN
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the cooled exterior surface with a slightly
damp cloth or sponge with some mild soap solu-
tion.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Wash the cup in warm soapy water after each
use.
NOTE: No parts are dishwasher safe.
6
• Switch OFF the appliance by turning the power
switch to the "0" position (Level position) if the
operation is finished.
• Unplug the appliance from the electrical power
supply.
• Put out the cup for drinking.
NOTE:
• Do not operate the appliance for more than 3
minutes at one time or without milk ingredient
inside the cup to prevent overheated.
• Different milk may have different froth outcome.
• Make sure the cup is safely placed in the machine
before starting operation.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
• Store the appliance in a cool, clean and dry place.