TREND R/STAND/A Traduction Des Instructions Originales page 3

EN - ADJUSTABLE BENCH TOP ROLLER STAND
Dear Customer,
Thank you for purchasing this Trend product, which should give lasting performance if used in
accordance with these instructions.
TECHNICAL DATA
Body size 260mm x 130mm
Roller size 25mm diameter x 250mm
Height adjustment 50mm to 160mm
Maximum load 62kg
Weight 2kg
The following symbols are used throughout this manual.
Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance
of the instructions.
Refer to the instruction manual of your power tool.
This unit must not be put into service until it has been established that the power tool to be connected
to this unit is in compliance with 2006/42/EC (identified by the CE marking on the power tool).
INTENDED USE
This adjustable roller is intended for use with mitre saws mounted on a bench or other flat surface to
support lengths of material.
SAFETY
Please read and understand the safety points in these instructions as well as you power tool
instructions.
PLEASE KEEP THESE INSTRUCTIONS IN A SAFE PLACE
Keep fingers away from the roller and raising mechanism.
Please do not modify the product.
Ensure stand is on a flat surface.
Safety Points
1. Disconnect power tool attachment from power supply when not in use, before servicing, when
making adjustments and when changing accessories such as cutters. Ensure switch is in "off"
position and cutter has stopped rotating.
2. Read and understand instructions supplied with power tool, attachment and cutter.
3. Current Personal Protective Equipment (PPE) for eye, ear and respiratory protection must be
worn. Keep hands, hair and clothes clear of the cutter.
4. Before each use check cutter is sharp and free from damage. Do not use if cutter is dull, broken
or cracked or if any damage is noticeable or suspected.
5. The maximum speed (nmax) marked on tool or in instructions or on packaging shall not be
exceeded. Where stated, the speed range should be adhered to.
6. Insert the shank into the router collet at least all the way to the marked line indicated on the
shank. This ensures at least ¾ of the shank length is held in collet. Ensure clamping surfaces
are clean.
R/STAND/A
-1-
English