Maintaining And Servicing The Power Tool; Trouble Shooting - Bostitch DSW-3519 Manuel D'instructions Et D'entretien

MAINTAINING AND SERVICING THE POWER TOOL

A) Blow dirt and dust out of all air vents with clean, dry air at least once a week. To
minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection
when performing this.
B) Never use solvents or other harsh chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic materials used in these parts. Use
a cloth dampened only with water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid
C To obtain service on your BOSTITCH power tool contact BOSTITCH customer service at
1-800-832-3080 for the location of the service center in your area.

TROUBLE SHOOTING

PROBLEM
Skipping
fasteners/
intermittent
feed
Fasteners jam in
the tool
Slow drive
speed or stalling
Poor clinch
CAUSE
Loose magazine
Fasteners out of spec.
Dirt/debris in the magazine
Dirt/debris in the drive channel
Wrong size fasteners
Bent fasteners
Broken/chipped driver
Worn pusher
Loose magazine
Fasteners out of spec.
Dirt/debris in the magazine
Dirt /debris in the drive
channel
Worn/damaged pusher spring
Discharged Battery
Depleted Battery
Cardboard too thick
Wrong leg length setting
Worn driver guide
Broken/bent clinchers
CORRECTION
Re-engage the magazine
release lever
Replace with recommended
fasteners
Clean and dry the magazine
Clean the drive channel
Replace with recommended
fasteners
Discontinue using these
fasteners
Replace driver
Replace pusher
Re-engage the magazine
release lever
Replace with recommended
fasteners
Clean and dry the magazine
Clean the drive channel
Replace pusher spring
Recharge battery
Replace battery
Reduce cardboard thickness
Set leg length according to
clinchers and fasteners
Replace the driver guide
Replace clinchers
17-ENG