Operation; Operating The Tool; Tool Operation Check - Bostitch DSW-3519 Manuel D'instructions Et D'entretien

OPERATION

Operating the Tool

1. Install the battery on the tool.
2. Grasp the handle of the tool with one hand ensuring to depress the safety lever.
3. Align the tool on the work piece using the marks on the side of tool to indicate where
the fastener is ejected.
4. Depress the trigger to actuate the tool.
5. Once the cycle has completed move the tool to the next location.
SAFETY LEVER RELEASED POSITION
ALIGNMENT

Tool Operation Check

Remove all fasteners from tool before performing tool operation
check.
TRIGGER OPERATED TOOL
A. With finger off the trigger, hold the tool with a firm grip on the handle ensuring that
the safety lever is depressed.
B. Place the nose of the tool against the work surface.
C. Pull the trigger to drive.
THE TOOL WILL CYCLE EACH TIME THE TRIGGER IS PULLED! THIS IS A FULL
CYCLE TOOL. PULL THE TRIGGER, AND CLINCHERS WILL DISCHARGE AND
RETRACT.
IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS
MANUAL OBSERVE THE FOLLOWING FOR SAFE OPERATION:
• Use the BOSTITCH tool only for the purpose for which it was designed.
• N ever use this tool in a manner that could cause a fastener to be directed
toward the user or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle.
• Do not alter or modify this tool from the original design or function.
• Always be aware that misuse and improper handling of this tool can cause
injury to yourself and others.
• Never leave a tool unattended with the battery attached.
MARKS
SAFETY LEVER DEPRESS POSITION
14-ENG