ACD Piccolo Manuel page 20

Page 1 Façade
Assemble the ridge plate with the bulges pointing downward, in the bolt slots.
ATTENTION: SEE PICTURE Page 1B: only with S1 and R2 greenhouse types: The corner profile roof (profile G for R2
green houses,profiles J & K for S1 greenhouses) has a little hole (Ø3); that profile must be assembled so that this little hole is
situated at the side of the ridge.
You assemble 2 façades.
Page 2 Stop Bolts
During the entire assembly !10! stop bolts are placed!!!
Page 4 Sidewall + stop bolts
During the entire assembly !2! stop bolts are placed, for greenhouses with 7& 8 windows, there are !3! stop bolts provided. You
assemble 2 sidewalls.
Page 5 Assembly
You now have 2 façades and 2 sidewalls.
Slide the panels one into the other until the end, the stop bolts are immediately tightened firmly and definitively.
Page 6 Roof
- First install the ridge (profile C) on top of the 2 façades and fix it definitively with the stop bolts.
- Greenhouses that are 7 & 8 windows long are provided with 2 glass rods (profile A) of each 2 stop bolts.
- Place the glass rods (profiles A) between the sidewall and the ridge you just put in place (profile C) .
- Assemble the traction strips (profiles B) to the ridge (profile C) in the corner and subsequently together with the glass rod (profile A) at the
sidewall.
ATTENTION 1: the traction strips start from the façade in the ridge and go down to the gutter. (See detail pag drawing "ROOF")
ATTENTION 2: If you bought a ridge decoration, mount it on the ridge profile before mounting the ridge profile itself
Page 7 Preparation of the Glass
Put the construction in its definitive place; upon installation of the glass the construction will be too heavy to move it easily. For a
smooth installation of the glass, we put the construction square and level.
Square by measuring from one corner to the other in both directions and by making both equal.
Level by bringing the 4 corners of the construction at the same level.
R