Bimar HF205 Notice D'instructions page 13

the appliance's plug, have the plug replaced with a suitable model by a qualified
professional, who should ensure that the cord is suitable for the power rating of the
appliance (10A). Check that other appliances with high absorption are not connected
to the power line to avoid overloading and fire hazards. The use of adaptors or
extensions is generally not advisable; if it is necessary to use them, they must comply
with safety regulations and the total current (amps) must not be rated lower than the
maximum current of the appliance.
• Before each use, check that the appliance is in good condition and that the power
cord is not damaged: if in doubt consult a qualified professional.
• Ensure that the power cord is correctly positioned and does not come into contact
with hot parts or sharp edges, or become wound around the appliance itself and is
not twisted.
• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable material
(curtains, tapestries, etc.), from flammable gases or explosive objects (spray cans)
and from materials that can be deformed by heat. Make sure there is 120 cm of free
space in front of the fan heater and 50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on
shelves), level (since the appliance could tip over) and heat resistant.
OPERATION
The device functions both as a fan heater with 2 power levels and as a ventilation fan
with 2 ventilation speeds.
The device features electronic control (1) of its functions, as described below:
Standby-ON
-
"
button selects:
-
-Fan: Normal "
-Heating: Eco (hot air) "
fan operates on its own for about "15" seconds to cool the device before
switching to standby mode.
button regulates the room temperature in the heating mode required: (18
-
or 21 or 24 or 27 or 30) °C. Once the set temperature is reached, the device
switches to standby mode, restarting when the temperature falls again.
The software saves the last function used
-
The LEDs display the functions being used
-
The device is equipped with:
anti-overturning switch: stops operation if the device is overturned
-
button: operates the fan and/or sets the device in standby "
" , Sprint "
" and Rapid (very hot air) "
"
13
": after use the