Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. Connect wiring.
Connect power cable to housing with appropriate UL
approved connector. Make wiring connections as shown
in "Wiring Diagram" section. Re-install wiring panel and
secure with screw from parts bag.
8. Mount fan to ceiling structure.
Mount housing to ceiling structure with standard
drywall or wood screws in locations shown.
*
Center hole optional.
6
WIRING DIAGRAM
DUAL CONTROL
(purchase separately)
SWITCH BOX
LIGHT
FAN
120 VAC LINE IN
9. Connect 4-in. round duct.
Pull existing ducting through housing discharge
opening.
Attach and tape ducting to duct connector.
Push connector/ducting back through opening.
Engage tabs and secure with screw from parts
bag.
3
2
4
Install blower. Finish ceiling, then
install grille.
See Steps 9 & 10 on Page 5.
BLACK
WHITE
RED
GROUND
(bare)
WIRING PLATE
1
TABS
RECEPTACLE
(LIGHT)
RECEPTACLE
(FAN)
Publicité
Table des Matières
