NuTone ROOMSIDE AERN100SN Instructions D'utilisation Et D'entretien page 5

9. Install blower.
Re-install blower. Secure blower with 2 screws from parts bag and plug
blower into black receptacle.
10. Finish ceiling, then install grille.
Pre-assemble mounting rod to grille pan using lock washer and jam
nut. Hand-tighten jam nut - plus 1/4 turn with a wrench (10-15 in.-
lbs.). Do not overtighten jam nut.
Plug light into receptacle in housing. Attach grille pan to housing
with 2 grille mounting screws. Pull out sliding shade hook (see
arrow) and install glass shade using hardware as shown. Do not
overtighten finial nut. Push sliding shade hook back into place over
glass shade.
JAM NUT
LOCK
WASHER
MOUNTING
ROD
FELT WASHER
FINIAL WASHER
FINIAL NUT
GRILLE
BRACKETS
LIGHT PLUG
GRILLE
PAN
SLIDING
SHADE
HOOK
(2) GRILLE
MOUNTING
SCREWS
FLAT WASHER
GLASS
SHADE
FELT WASHER
RETROFIT
5. Remove old fan.
Enlarge ceiling opening (if necessary)
to 9¾" parallel to joist) by 10½"
(perpendicular to joist). Leave ductwork
and wiring in place.
1
10½-in.
9¾-in.
6. Fold mounting ears flat
against housing.
JOIST
2
5