Publicité
Les langues disponibles
Les langues disponibles
8046492
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a
malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use with
your tool.
1.
Wrap the external threads of the coupler plug with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2.
Screw the coupler plug into the tool's air inlet and tighten with a
wrench until snug.
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected
directly to the air tool. To overcome this, connect a leader hose to the
tool. A quick coupler may then be used to connect the leader hose to
the air line hose.
CABINET INSTALLATION
IMPORTANT! Scan the code below to watch the
assembly video.
8
Floor-Model Abrasive Blasting Cabinet
For technical questions call 1-800-665-8685
V1.0
Publicité
