Scope Of Delivery; Unpacking The Appliance; Assembly Instructions; Remote Control - Profi Care PC-TVL 3090 Mode D'emploi

• Different battery types or new and used batteries must
not be used together.
• Batteries can leak and lose battery acid. If the remote
control is not used for a long period of time, remove the
batteries.
• In case of battery leakage, make sure not to rub the
liquid into your eyes or mucous membranes. In case of
contact, wash your hands and rinse your eyes with clear
water. Seek medical attention if any discomfort persists.
• Batteries are not to be disposed of together with domes-
tic wastes. Dispose of the used batteries at the relevant
collection bin or at your dealer's.

Scope of Delivery

1 × Remote control
1 × Tower
1 × Base plate
1 × Securing nut for base plate (pre-assembled)
Overview of the Components
1 Indicator lamp (Sleep)
2 Indicator lamp (Oscillation switched on)
3 Indicator lamp (Wi-Fi)
4 Segment display
5 Indicator lamp H (Hours)
6 SWING button (Oscillation)
7 MODE button (Wind change functions)
8 ON / OFF button (Switching the appliance on / off)
9 TIMER button (Electronic timer)
10 SPEED button (Speed)
11 Indicator lamp (Nature)

12 Remote control

13 Base plate
14 Securing nut
15 Tower
16 Storage compartment for remote control

Unpacking the Appliance

1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".
PC-TVL3090_IM

Assembly Instructions

1. Position the housing with the open side facing upwards.
NOTE:
It is best to place a blanket underneath so that the
housing is not damaged.
2. Pass the connection cable through the hole of the base
plate so that the mains plug is located on the underside
of the base plate.
3. Remove the securing nut from the bottom of the housing.
4. Place the base plate on the housing. The base plate can
only be mounted in one position. Pay attention to the
recesses and locking pins.
5. Thread the cable into the recess provided on the base
plate.
6. Screw the base plate in tightly using the securing nut.
7. Now turn the fan over and place it on a suitable solid
surface.
Remote Control
• Remove the remote control from the compartment on the
back of the appliance.
• The range of the remote control is limited. When using
the remote control, please ensure that there are no
obstacles placed between it and the sensor on the
appliance.

Fitting Batteries into the Remote Control

(Batteries not supplied)
If the range of the remote control is reduced during use,
please proceed as follows:
1. Open the lid of the battery compartment on the rear of
the remote control.
2. Insert 2 MICRO batteries of type R03 "AAA" 1.5 V.
Please ensure the correct polarity. Details can be found
in the battery compartment.
3. Close the battery compartment.

Putting into Service

Electrical Connection

1. Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the appli-
ance. You can find this information on the nameplate.
2. Connect the appliance to a duly installed protective con-
tact socket. You will hear a signal and all of the symbols
in the display will light up for a moment. The indicator
light will flash quickly.
41
15.01.21