Publicité
Les langues disponibles
Les langues disponibles
PROPER SET-UP CONFIGURATIONS
We recommend that you use your
Superyard only as an enclosure, not
as a barrier. See FIGURE 7 at right
for proper configuration.
DOOR OPERATION
Your enclosure comes from the factory
with the door safety lock 'LOCKED'. To
unlock, move the center lock up to the
unlocked position (as shown in
FIGURE 8).
To OPEN the door, slide and keep
holding top latch in pulled-back
position. Lift door up and over
threshold, then open out (as shown in
FIGURE 9).
To CLOSE the door, slide and keep
holding top latch in pulled-back
position. Lift door up over threshold.
Engage door in frame catch as shown
in FIGURE 10. Set door down in
threshold and release latch.
TO LOCK the door, move center lock
down to locked position once child is
secure.
TO DISCONNECT PANELS
To disconnect two adjoining panels,
select one of the three joints where
the panel pushes down (panel 1), as
shown in FIGURE 11 at right.
Gently press down on panel 1 while
lifting slightly on panel 2. This will
enable you to slide pin "C" free of
cylinder "D" (see FIGURE 6). Then lift
up on panel 1 until opening "A" (see
FIGURE 5) is free of pin "B".
FIGURE 7
INCORRECT
FIGURE 8
FIGURE 10
Frame
Catch
FIGURE 11
Pin C
PANEL 1
Opening
A
CORRECT
INCORRECT
FIGURE 9
D
Pin B
Page 5
PANEL 2
Publicité
