Publicité
Les langues disponibles
Les langues disponibles
Page 4
SET-UP INSTRUCTIONS
Begin setting up your enclosure by
FIGURE 3
unsnapping the gray carrying strap and
carefully unfolding the panels to form a
hexagon, as shown in FIGURE 3 at right.
The North States logo on the door panel
should face out.
When you have finished unfolding the
panels, there will be two unconnected
panels arranged, as shown in FIGURE 4 at
right. Make certain that the pin in plunger
B is up as shown.
Begin connecting the panels together by
gently lifting up on panel 1 and setting the
FIGURE 4
opening "A" (as shown in FIGURE 5) over
pin "B" located on panel 2.
PANEL 1
PANEL 2
D
P
C
Now locate the slot on the lower end of
cylinder "D", as shown in FIGURE 6. This
slot tapers to an opening that
accommodates pin "C".
Gently press down on panel 1 while
aligning pin "C" with the slot in cylinder
"D". While maintaining downward
A
B
pressure on panel 1, lift slightly on panel 2,
and slide pin "C" through the slot and into
FIGURE 5
the opening as shown.
FIGURE 6
PANEL 1
PANEL 2
PANEL 1
PANEL 2
EXTENSION INSTALLATION
Two-panel extensions that are colored
appropriately for your yard are available
from your dealer (see page 2).
SLOT IN
CYLINDER
OPENING A
The extension contains two additional
D
PIN B
panels that enable you to expand the size
PIN C
of your enclosure from 18.5 square feet to
34.4 square feet (1.72 m
to 3.2 m
).
2
2
The extension is installed by following the
"SET-UP INSTRUCTIONS" that appear
above.
Publicité
